Pro/rNGINEER Wildfire Tips & Tutorial (Pro/E Wildfire 4.0, Wildfire 3.0, Wildfire 2.0 and 2001)

FLASH TIPS: Pro/E Round Transition – Stop at Reference

(FLASH) TIPS: Rounds transition in Pro/E – Stop at Reference


Version: Pro/E Wildfire, Wildfire2.0, Wildfire3.0, Wildfire4.0

How to create round which is stop at desired datum plane in Pro/E Wildfire?
You may want to create round which is not applied thru the entire selected edge. How to do that?




Method:

1. After selecting the round edge, press and hold RMB and choose Show Transitions.
(Alternatively you can click the transition icon ProE round transition icon in Pro/E round dashboard)
2. You will see the preview for the transitions at both end of the round edge. Select the end which you wish to modify (Highlighted in Yellow when selected).
3. Next, press and hold RMB again and choose the option Stop at Reference
4. Pick the datum plane which the round should stop.



More Tips (FLASH) TIPS: Round stop at Tangent Edges in Pro/E

ProENGINEERtips.com is an independent website providing tips and tutorials for Pro/ENGINEER users.
ProENGINEER version covered: ProE 2001, Wildfire, wildfire 2.0, Wildfire 3.0 and Wildfire 4.0
Pro/ENGINEER Wildfire and Pro/INTRALINK are the registered trademark of PTC.
© 2006 - 2012 www.proengineertips.com

Top Desktop version