Pro/rNGINEER Wildfire Tips & Tutorial (Pro/E Wildfire 4.0, Wildfire 3.0, Wildfire 2.0 and 2001)

FLASH TUTORIAL: Creating Hole Feature in Pro/ENGINEER Wildfire (Part 1)

FLASH TUTORIAL: Creating Hole Feature in Pro/ENGINEER Wildfire (Part 1)

Version: Pro/E Wildfire, Wildfire 2.0, Wildfire 3.0, Wildfire 4.0

There are 4 methods that you can fully constrain a hole feature in Pro/E Wildfire part Modeling.

Here is the summary:

1. 3 References (1 primary reference and 2 secondary references) with 2 linear dimensions
2. 2 References (1 primary reference and 1 secondary reference)

3. 1 Reference (1 primary reference only)
4. 3 References (1 primary reference and 2 secondary references) with 1 radial dimension and 1 angular dimensions

The steps are presented in the flash format and considering the loading time, this thread has being divided into 2 parts.

1. 3 References (1 primary reference and 2 secondary references) with 2 linear dimensions

In this method, a surface is selected as the primary reference. The secondary references could be surfaces or edge. 2 linear dimensions to the secondary references are needed.

2. 2 References (1 primary reference and 1 secondary reference)

An axis is being chosen as the primary reference in this case. After the primary reference pick, the surface is selected as the secondary reference. No dimension is required in this method.

continue at - FLASH TUTORIAL: Creating Hole Feature in Pro/ENGINEER Wildfire (Part 2)

ProENGINEERtips.com is an independent website providing tips and tutorials for Pro/ENGINEER users.
ProENGINEER version covered: ProE 2001, Wildfire, wildfire 2.0, Wildfire 3.0 and Wildfire 4.0
Pro/ENGINEER Wildfire and Pro/INTRALINK are the registered trademark of PTC.
© 2006 - 2012 www.proengineertips.com

Top Desktop version