Pro/rNGINEER Wildfire Tips & Tutorial (Pro/E Wildfire 4.0, Wildfire 3.0, Wildfire 2.0 and 2001)

TUTORIAL: Surface Modeling in Pro/E Wildfire – Extend Surface (Bottle Tutorial 5)

TUTORIAL: Surface Modeling in Pro/E Wildfire – Extend Surface (Bottle Tutorial 5)

Versions: Pro/E 2001, Wildfire, Wildfire2.0, Wildfire3.0

This time, we are going to extend the body surface to make it overlaps with the top surface. You can continue using the model from the previous Bottle’s Surface Modeling tutorial or download the file used in this tutorial by clicking here – Part5 (bottle_05.prt).

1. Open the bottle_05.prt file and resumes the suppressed features. (Skip this step if you are continuing developing from previous Bottle’s Surface Modeling tutorial)

ProE Extend Surface start

2. At the screen bottom, choose Geometry on the selection filter

ProE selection filter

3. Next, pick the edge of the body surface as shown below (Swept Blend Surface). Press and hold the ‘Shift’ key and then pick the adjacency edge to select the intend edge.

ProE Extend Surface select edge ProE Extend Surface select intend edge

4. After that, click Edit > Extend to start the Extend tool. Note that without any edge selected, the Extend command will not be activated.

ProE Extend Surface command

5. The extended surface should be shown in the light weight preview. Besides, the Extend tool dashboard gives you more control options in the extend tool.

ProE Extend Surface preview

ProE Extend Surface tool dashboard

6. The model should look like below by now.

ProE Extend Surface done

 

 

 

ProENGINEERtips.com is an independent website providing tips and tutorials for Pro/ENGINEER users.
ProENGINEER version covered: ProE 2001, Wildfire, wildfire 2.0, Wildfire 3.0 and Wildfire 4.0
Pro/ENGINEER Wildfire and Pro/INTRALINK are the registered trademark of PTC.
© 2006 - 2012 www.proengineertips.com

Top Desktop version